Portable UVB Narrowband 311nm Lamp Fixture and 49 similar items

All-in-One UVB Lamp Kit ? Complete Set, Ready to Use, No Extra Parts Needed Package content: 1 x Stand holder(Unbranded) 1 x Genuine PL-S 9W/01/2P 9W Replacement Lamp 1 x 110-120V US adapter Power supply adapter 1 x eye protection Goggles =========================== 311nm narrow band lamp Model: PL-S 9W/01/2P EAN: 8711500868916 MPN: 927901700121 Cap-Base: G23 Cap-Base Information: 2 Pins Bulb: 2xT12 Length: 6.5 inches Diameter: T4, 1/2 inches (12mm) Life to 50% failures EM: 8000 hr Life to 50% failures EM: 8000 hr Lamp Wattage Technical: 8.6 W Lamp Voltage: 60 V Lamp Current: 0.17 A Compatible with: Most UVB-Narrowband handheld devices including: National Biological Corporation DermaLume 2X Dermalight 90 (made for NBC by Dr. Honle), Daavlin Dermapal, Dermfix 1000MX, Sigma SH1 SH2, Kernel KN4003B KN4003BL KN4006B KN4006BL, Dr. Honle Dermalight 80, Waldmann UV109, UV-Biotek Hand-Held Wand (made for UV-Biotek by Kernel). DermaHealer Compact Handheld models. Instructions for Use: Initial Use: start with an initial time of 30-40 seconds, illuminating the skin area from a distance of 3 cm. After illuminating one area, move to the next area and continue for 30-40 seconds. After completing all areas, observe the skin the next day for any mild redness (erythema) reaction. Important Note: There is a common misconception that if no mild redness appears after 30-40 seconds of illumination on the first day, you should increase the time. This is incorrect. The mild redness reaction can only be seen within 24 hours, i.e., the next day. Our skin has a maximum tolerance level, and exceeding this time can cause severe sunburn, blisters, and pain. If mild redness appears the next day, continue with 30-40 seconds for the next treatment. If no redness appears, increase the time by 15-20 seconds until mild redness is achieved. Remember, mild redness indicates the optimal time for your skin; deep redness indicates overexposure. How to Protect Normal Skin: For normal skin, you can use a piece of unused cloth or clothing, cut a hole to fit the area, and cover it. Alternatively, wrap the cloth around the machine, exposing only the necessary part.