DPT-C-L Digital Piezo Translator (Dpt) and 50 similar items

DPT-C-L Digital Piezo Translator (DPT) MOVING 70 µm MODULE QUEENSGATE NEW NOS $999 NEVER USED!! Digital Piezo Translator(DPT) Series Product Description www.nanopositioning.com Applications The Digital Piezo Translator (DPT) is a piezoelectric translation device capable of moving up to 70 µm with very high linearity and essentially perfect repeatability. The hysteresis is less than a nanometer. The DPT is the result of more than 100 man years of R D and attains an accuracy 20 times higher than any other device on the market. Ordinary piezoelectric translators are non-linear and exhibit hysteresis and creep. To overcome these deficiencies a position sensor is built into each DPT. The output of this sensor controls the voltage on the piezo stack removing the hysteresis, nonlinearity and creep. Each DPT is supplied with a calibration curve which can serve as a basis to correct the very small residual non-linearity. The position sensing circuitry and piezo drive amplifier have been miniaturized and packaged in the stand-alone CM Control Module, which requires only 15 V to operate. This makes the DPT particularly suitable for OEM applications. The Control Module comes complete with analog input, 14 bit parallel digital interface, status lines and ready signal. To operate the DPT, the minimum required is a Control Module. For laboratory applications, up to three CM can be mounted in an AX301 host unit, which provides position display, optional IEEE488, RS232 and parallel interfaces, and allows manual control of the DPT. Scanning Probe Microscopy TFI, MR, GMR Head Testing NSOM Precision Engineering Interferometry Metrology Adaptive Optics Precision Beam Steering Translators The DPT-C is constructed of Zerodur and Invar. It is preloaded in a 20mm diameter stainless steel housing, with M3 threaded end pieces and a 2 meter long flying lead. Each DPT-C is individually calibrated, and a calibration curve is supplied. The DPT-C is repeatable to better than 1 nanometer. DPT-C-S DPT-C-M DPT-C-L Range (µm) 15 35 70 Length (mm) 42.2 76.7 127.8 Diameter (mm) 20 20 20 Mass (gms) 70 110 170 Linearity (%) 0.1 0.15 0.15 Temp Coeff (nm C-1) 15 25 35* Tilt (arcsecs µm-1 ) 0.5 0.5 0.5* * Typical specification for information and guidance (not guaranteed in normal productio SALE.. BE QUICK!!! ABAY ELECTRONICS is an asset recovery wholesaler specializing in new and used surplus equipment. We are not a representative of any manufacturer listed; all names, logos, descriptions and other related information are trademarks of their respected companies or manufacturers. All items listed are identified as either new or used and the new may be older surplus.We list all items to the best of our ability and aim to provide the customer with as much information as possible. Yaba1957 is not liable for any products sold, the customer is responsible for proper testing, installation and use of equipment purchased. No warranties are expressed or implied.The sale of this item may be subject to regulation by the U.S. Food and Drug Administration and state and local regulatory agencies. If so, do not bid on this item unless you are an authorized purchaser. If the item is subject to FDA regulation, I will verify your status as an authorized purchaser of this item before shipping of the item.Domestic Shipping . We ship using UPS and FedEx to provide en-route package tracking.International Shipping We ship using UPS, FedEx and USPS. Items shipped by UPS and FedEx are more efficient and provide customers with en-route tracking. The sale of this item may be subject to regulation by the U.S. Food and Drug Administration and state and local regulatory agencies. If so, do not bid on this item unless you are an authorized purchaser. If the item is subject to FDA regulation, I will verify your status as an authorized purchaser of this item before shipping of the item."