*Keep in mind 3D printed parts will have texture. Think of them like model car parts. May need a light sanding, A xacto knife trimming small supports or paint if you wish. Usually 1 side was attached to the printer bed and it may be the roughest. Lightly sand and usually fine. Thanks again for your interest. Used 3D printed semi lowboy flatbed as shown. Sold as is! Other Stompers listed. *These are from my personal collection. In most cases I ended up picking 1 and listing the double. Photos show conditions. Zoom in and take a look. Stomper only other toys not included! More pics are up on the Stomper Museum! ?---------------------------------------------------------- Common Stomper issues etc.. 1. Ran at the time i listed but if you open it theres no guarantee it will run without some effort. When Stompers sit they rarely run without tapping the bottoms etc.. look up my video on you tube on how yo get them running. 2. Rims are typically cracked and sometimes fall off. Crazy glue can help but be careful you don't glue the rim to the chassis. No returns!